• 11 Oct, 2022
• By EPIC Powder
• 2 Comments

Benyoumingke Powder Machinery, the most effective way to solve the internal speed difference of small air flow classifier

Since the

small air classifier

, the working efficiency of various industries has also been improved, and it plays a pivotal role in the pharmaceutical, chemical, food and other industries. According to the degree of fragmentation and fineness of the small air classifier, it can not only cut feed vines and tall stalks, but also destroy the commonly used sweet potato, corn and other machinery in the village. With the extension of service time, some failures often occur. This paper mainly discusses how to solve the problem of internal velocity difference< Br/>Why is there a speed difference in a small gas separator? This is mainly because there is a speed difference between the hammer blade and the material hammer in the machine. If this speed difference is not handled, the working efficiency of the grinder will be affected. Therefore, it is very important to reduce the speed difference inside the machine, and the following measures can be taken:; In the pulverizer, the particle composition in the inner chamber of the pulverizer will also change after the pulverizer has just started to work and worked for a period of time; In the crusher parts, the hammer is easy to wear. After the wear of the front end of the hammer, the change of the hammer screen gap will increase, and the output will decline, which is difficult to last. Of course, for the needs of the production test of a certain mill, for a certain raw material, a certain screen hole, determine the appropriate hammer screen gap and suction, regardless of the service life of the screen and hammer, you can obtain very high crushing efficiency data in a short time, but in the production of feed crushing, The specific data determined according to the working experience of the operators and the technical content of the

crusher

itself are different. The personnel with rich operating experience and their labor also need very high use costs, However, the increase of air suction will also increase the wear of hammer and screen, and the efficiency will not last. At the same time, the power consumption of suction will also increase< Br/>III. Make rational use of the reverse burrs on the screen: put one side of the hair on the screen to increase friction, but the efficiency will disappear soon after the screen burrs are polished, and the duration is about 30 minutes to 1 hour< Br/>IV. Place the friction plate in the grinder: the friction plate has the function of blocking the material ring, but its function is limited. First, the teeth of the friction plate act on the front of the hammer, so the friction surface is small, and the wear of the hammer blade also has durability problems; Second, the angle of the friction plate occupying the screen. If the screen surface area is too large, the area of the friction plate will decrease, and the screen area will decrease