• 24 Oct, 2022
• By EPIC Powder
• 2 Comments

The "noise" of air flow pulverizer is too large, so it is easy to start from these aspects

The whole system of air flow pulverizer adopts closed pulverization, with very little dust, very low noise, and very clean and environment-friendly production process. Therefore, the jet mill is a kind of crushing equipment that conforms to the environmental protection standards and is highly appreciated by the powder processing users

The feeding devices of air flow pulverizers are usually high-pressure gas suction, screw feeding and screw feeding. It is the standard for vertical turbine classifiers. Grinding and grading are completed simultaneously. By adjusting the speed of the classifier through frequency conversion, the fineness of the product can be adjusted at will. If a processing process requires more than one granularity segment, two or four classifiers can be added on the basis of a standard classifier to make the machine a two to five crushing and grading classifier< Br/>Generally speaking, there are some sounds during operation. It is normal that the air flow pulverizer will make a sound of crushing when crushing raw materials. However, if the sound becomes noise, it becomes a problem if the sound becomes too loud. How to solve the problem of excessive noise? Let's take a look at it< Br/>1. Add lubricating oil to the rotating parts, and adjust if the bearing and shaft are dislocated; If the bearing is worn, replace the bearing< Br/>2. Noise will also be generated during crushing. The cooling jacket distributes water in the crushing chamber, which can be used to reduce the temperature< Br/>3. Install a muffler on the fireplace of the crushing chamber< Br/>4. Damping equipment, such as damping plate< Br/>Therefore, when we choose and purchase an air flow pulverizer, we should choose a good one. In order to avoid unnecessary failures, no matter whether the feeder is a double solenoid feeder or not, there are more optimization technologies in the double solenoid feeder. Not only is the twin screw feeder good, but compared with the tablet pressure and feed pressure, the crushing effect of the crusher with larger tablet pressure is generally better, such as the air compressor. It is 8kg pressure, so the crusher can work under 8kg pressure, but the feed pressure of some crushers is greater than that of the crusher. If the crusher is under 8kg pressure, first ensure that the feed pressure is 8kg, and the pressure of the crusher is less than 8kg, otherwise rebound will occur< Br/>It is better to have only one crusher at the entrance, because Apis is more valuable. If there are two or three materials at the inlet, such as two or three materials at the same time, the grain size of these three materials will be different. At that time, it was impossible to mix the three materials evenly, which would cause great waste and trouble. For equipment above kg, it is recommended to use a grinder with a large filtering area. The production process is relatively continuous and does not stop, so it is not easy to block< Br/>The above is about how to solve the problem of excessive noise in the air flow crusher, which I have compiled for you. Do you understand it better? Air flow grinder is one of the main products of Qingdao Youmingke. With the technical advantages of high precision, high efficiency and good stability, the product has a high reputation in various industries. Qingdao Youmingke air flow grinder can provide free incoming material experiment and detection. New and old users are welcome to call to discuss cooperation