• 13 Oct, 2022
• By EPIC Powder
• 2 Comments

Surface cleaning of jet mill and precautions for use of motor Umico powder machinery

Ultrafine powder is widely used in plastics, rubber, electronics, cables, paints, coatings, abrasives, pharmaceuticals, cosmetics, ceramics, building materials, food processing and household appliances, so it is used as equipment for manufacturing ultra-fine powder&mdash& mdash; The demand for jet mill in the market is also increasing. Airflow pulverizer is an important means of dry production of ultra-fine powder at present, and it is warmly sought after by various industries. So what problems should we pay attention to in the use of air jet mill? Now let's introduce it to you

After a long time of use, when the equipment surface is not as bright as when it was bought, you can make the equipment by yourself“ A new look”. The materials used are very simple. Apply an appropriate amount of pickling passivation paste on the stainless steel surface to be treated, with a thickness of 1-2 mm, and keep it for 10-50 minutes or longer (depending on the dirt and plate material). In the treatment project, it is better to brush several times with a brush. After the oxide skin and rust on the surface are completely removed, clean it with clean water (lime water or alkaline water is better) to avoid rust back. If it is used for the first time or has no use experience, it must be used in large quantities after a small amount of trial is satisfied. In this way, the equipment will be restored to a new look< Br/>During the operation of the air flow mill, the motor, as a main transmission part, should pay attention to some problems in use< Br/>The first is the driving power supply. Its advantages and disadvantages have a great impact on the operation of the motor. Special attention should be paid to its use. Advanced and stable power supply should be used as far as possible according to the operation requirements to meet the operation performance of the motor< Br/>In addition, if the load is large, it should be started at a low frequency, then the load should rise to the operating frequency, and it should also drop from the operating frequency to the appropriate frequency before shutdown. In the process of operation, it should be avoided to suddenly adjust and control the airflow crusher with large parameters< Br/>During the use of the jet mill, there are many points that should be paid attention to, especially in the maintenance. Qingdao Youmingke is the source manufacturer specializing in the production of jet mill. It can provide 24-hour online consultation on jet mill, and provide equipment scheme, quotation, etc