• 17 Nov, 2022
• By EPIC Powder
• 2 Comments

EPIC Powder Machine needs to be turned off during cleaning

When the air flow pulverizer is cleaning, the main power supply can be turned off, and then the residual dust in the machine can be directly removed with a brush. You must remember to clean it layer by layer. After the hopper is removed, the four screws on the base can be removed first, and then the hopper can be removed. When the screen is removed, you can directly open the door of the airflow crusher, and then you can remove the screen after zui. Before use, all fasteners shall be checked for tightness, and the running direction of the spindle shall be correct to avoid damage to the machine. Lubrication shall be carried out according to the specified requirements to ensure normal operation of the machine. Before the materials are added to the crusher, no sundries shall be mixed in to avoid damage to the crusher. If there are any foreign matters or sundries in the air flow crusher, they shall be handled in time to avoid damage to the cutter

During the use of the pneumatic pulverizer, if there is any abnormality, it should be handled immediately to avoid greater loss. Some parts should be checked regularly, and if there is any damage, it should be replaced immediately. Mismatch of conveying equipment will lead to weak or calm air in the blocked drain pipe. To find out the fault, first of all, the export transportation equipment should be clarified, and the feed quantity should be adjusted without change, so as to ensure the normal operation of the equipment. Under the action of the fan, the material is graded through the air at the feed inlet. The material is separated by centrifugation. After separation, the particles shall meet the requirements, enter the hydrocyclone, and then collect. If the particles do not meet the requirements, they shall be further separated until they meet the requirements. The crushed materials enter the classification room with the air flow rising, and the materials that meet the particle size requirements enter the collection system through impeller classification. The particles that do not meet the particle size requirements return to the grinding room for further crushing. The whole production process is fully closed and continuous operation, without dust pollution